Lap Siding Installation

Lap Siding Installation

Lap siding, additionally referred to as horizontal siding or clapboard, can be fabricated from wooden, fiber-cement, plywood, hardboard, or similar materials. Despite the variety of materials, set up techniques are essentially the identical, with some versions in fasteners, joints, and so forth.

Most lap siding is beveled, that means that the bottom facet is thicker than the pinnacle. As its name “lap” implies, a higher siding board laps over the board beneath it through 1 to 2 inches.

On thick profiles of siding, nails may be hidden, which means they may be driven into the top part of a board, so they are included by means of the decrease a part of the board above it. Otherwise, nails may be left uncovered and included via paint, wherein case they are pushed into the decrease portion of a board so that they bypass simply above the higher fringe of the board beneath them.

If you are planning to paint your siding, it’s an amazing concept to prime all of the portions on all facets earlier than installing them; that manner, the backsides will also be covered towards rot and the boards are much less probable to cup or twist. Usually reduce ends of boards before putting in the forums.

In a few custom installations, lap siding is carefully mitered at outside corners. This makes for a traditional appearance however requires excellent carpentry skills and forums which might be certain not to cut back. The technique mentioned here is a simpler and more commonplace one—installing corner trim first after which butting the siding to it.

More Similar Posts

No results found


Previous Post
Things to Consider Before You Repair Damage from Dry Rot

Leave a Reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.
You need to agree with the terms to proceed