Siding & Trim

Lap Siding Installation


Lap Siding Installation

Lap siding, additionally referred to as horizontal siding or clapboard, can be fabricated from wooden, fiber-cement, plywood, hardboard, or similar materials. Despite the variety of materials, setup techniques are essentially identical, with some versions in fasteners, joints, and so forth.

Most lap siding is beveled, which means that the bottom facet is thicker than the pinnacle. As its name “lap” implies, a higher siding board laps over the board beneath it through 1 to 2 inches.

On thick profiles of siding, nails may be hidden, which means they may be driven into the top part of a board, so they are included by means of the decrease a part of the board above it. Otherwise, nails may be left uncovered and included via paint, wherein case they are pushed into the decreased portion of a board so that they bypass simply above the higher fringe of the board beneath them.

If you are planning to paint your siding, it’s an amazing concept to prime all of the portions on all facets earlier than installing them; in that manner, the backsides will also be covered towards rot and the boards are much less probable to cup or twist. Usually, reducing the ends of boards before putting them in the forums.

In a few custom installations, lap siding is carefully mitered at outside corners. This makes for a traditional appearance however requires excellent carpentry skills and forums which might be certain not to cut back. The technique mentioned here is a simpler and more commonplace one—installing corner trim first after which butting the siding to it.

More Similar Posts